We must first understand the installation relationship between shaft mounted reduction motor and working machine.
In order to avoid the deflection of the main shaft of the working machine and the additional force on the bearing of the reducer, the distance between the reducer and the working machine shall be as small as possible without affecting the normal work, and its value is 5-10mm.
If the wrong type selection results in insufficient output of the equipped reducer. Some users mistakenly believe that as long as the rated output torque of the selected Trane reducer meets the working requirements, in fact, it is not. First, the value obtained by multiplying the rated output torque of the equipped motor by the reduction ratio is in principle less than the rated output torque of the similar reducer provided by the product sample, Second, the overload and actual driving capacity of the motor should be considered at the same time.
Hangzhou Chi Nai also wants to inform you that when installing the reducer on the foundation, the R series helical gear hard tooth surface reducer must first calibrate the installation centerline elevation of the reducer, and configure the levelness and relevant dimensions of its connecting parts.
When using the reducer, we must pay attention to its code of conduct, and there are fatal reasons for insufficient output for wrong selection. The shaft breaking problem occurs when the output of the reducer is too small. The shaft breaking of the reducer is a common problem.
When it comes to this, we need to know the installation method of the reducer. It is necessary to install belt pulley, coupling, sprocket and other connecting parts on the output shaft, and direct hammering is not allowed when installing these connecting parts, except for the broken shaft of the reducer caused by poor assembly concentricity at the output end of the reducer, In addition, the large working torque required by users must be less than twice the rated output torque of the reducer.